How To Cut Door Jamb

This is the end result your looking for not too low and not too high but just right. Perform Steps 1 through 5 of the previous section.

Pin On Floors

Set the depth of the cut to be the same as the depth of your hinge so that the hinge will rest flush on the door.

How to cut door jamb

. This line acts as. In this video I gonna show you how to easily cut metal door frame door jamb with a jamb saw for laminate flooring installation. As shown in this photo you can see the small piece of laminate and padding positioned up to the door jamb.

Remove the threshold and set it aside. As a safety precaution you must unplug the power tool before performing any adjustments. Cut the first miter on the head moulding piece.

Attach the jig to your door by screwing it in on both the top and bottom you can fill repaint these holes later. Set the power miter to a 45-degree angle. Go ahead and cut all the way across the frame being careful not to cut the door.

Add 34 inch clearance for an interior door or 14 inch for an exterior door plus the thickness of any flooring that will be added later. Also use a piece of the underlayment under the laminate so you can cut the jamb to the correct height. With a straight edge line it up against the mark that you made and make a cut using a box cutter or utility knife.

Hook the tape measure into the side jamb rabbets or dadoes and measure down a distance equal to the length of the door. Put in the rounded molding and I worry it will look funny over by the doors because I cant. Add -inch or whatever the thickness of your inset and then make a mark against the door jamb and molding.

Hook your blade on your oscillating tool. Turn it on and cut through the jamb moving the blade from left to right. If you do this without the pad then the jamb will be too tight for the laminate to flow freely.

Now that you have cut the frame go ahead and place a scrap piece of flooring next to the door frame. Step 4 - Preparing to Cut the Laminate Side. Check and double-check this measurement.

Adjust the depth of cut on your undercut saw to the height of the laminate side of the door jamb. Loosen and remove the threshold mounting screws. Put on a pair of goggles lay the saw on the floor grasp the handle and set the blade on the left side of the jamb.

TIP Go ahead and cut nice and tight to the scrap. Nail the head moulding piece to the door jamb. You will need to both of these to cut the proper height of the jamb.

Place a piece of the material you are cutting the door jamb to make room for in its location. Place the blade flat on the surface. Step 5 - Cutting the Laminate Side of the Door Jamb.

Make a mark before you cut another 45-degree miter with the power miter. TIP Go ahead and cut nice and tight to the scrap flooring. Then measure the length of the moulding from the inside point of the miter you just cut to the desired length.

Measure and Cut. Run it along the door jamb marking the problem areas with a pencil. Now do the same as step 1 with your blade laying on top of the scrap piece.

Line the square up with the measurement mark and extend the line around all four faces of the jamb. First of all you will need a scrap of laminate and then a scrap of the pad that will go under the laminate. Problem is now that the door jambs for the closet and room entry were under cut for the carpet and now thats also about resulting in a decent gap between it and my floor.

Place the jig in the correct spot on your door. Press the saw down against the laminate as you cut. Begin cutting the door jamb and slowly working your blade around the entire area you want to cut.

You dont want any extra space. You can use a variety of tools and I. Attach the included router bit to your router.

Some areas of the drywall may be acceptable and these spots will not need to be carved out.

Floor Young House Love One Young Family One Old House Love Young House Love Installing Hardwood Floors Floor Installation